Activate Address In Alarm Mode (H8/S9) - Panasonic EBL512 Operating Instructions Manual

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748
30.10
Action
"Access"
Scroll to menu S9.
"A"
Write the zone and
address.
"A"
"Return"
Write the zone and
address.
"A"
What happens by reset of the fire alarm(s) is depending on:
a) if you still are in menu H8/S9 and single reset is used
b) if you still are in menu H8/S9 and multiple reset is used or if you are logged out (by
pressing "Return" two times or automatically after 10 minutes).
Rev: 1

Activate address in alarm mode (H8/S9)

One alarm point (address), not a whole zone, can be set in alarm
status. The built-in LED in the alarm point (detector) will be turned
on to indicate the alarm. Among other applications, this function is
used for installations on ships.
NOTE! All outputs, standard and programmable, which would have
been activated by a real fire alarm from the same alarm point, will be
activated by this manual alarm as well.
Text in display
Activate address in alarm mode
Select zone: 000
Select zone: 123
POINT: 123-45
User definable text, if programmed
Select zone: 000
Select zone: 012
POINT: 123-45 LAST: 012-34
User definable text, if programmed
Operating Instructions Fire alarm system EBL512 V2.3.x
ACCEPT?
address: 00
ACCEPT?
address: 45
ACCEPT?
No.: 001
address: 00
ACCEPT?
address: 34
ACCEPT?
No.: 002
128
Comments
According to chapter
"Access code for
maintenance", see page
119.
S9
Press "A" to accept / start
the fire alarm.
Normal fire alarm
presentation in the control
unit(s) / FBPs display.
If more alarm points have
to be set in alarm status,
press "Return" to select
another zone - address and
continue as above.
Press "A" to accept / start
the fire alarm.