Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748
Rev: 1
2
2.1
2.2
2.2.1
2.2.2
2.2.3
2.2.4
2.2.5
2.2.6
2.2.7
Operating Instructions Fire alarm system EBL512 V2.3.x
Definitions / Explanations
Definitions / explanations / abbreviations / etc. frequently used or not
explained elsewhere in the document.
PEWF&STE AB
Panasonic Electric Works Fire & Security Technology Europe AB
Alarm points
Units, which can generate fire alarm (in the control unit), i.e. a sensor,
a conventional detector, a manual call point, etc.
Smoke detector
Two types of analog and conventional smoke detectors are available:
photo electric (optical) and ionization.
Sensor
Sensor = Analog detector
Analog detector
Contains an A/D-converter. The Control Unit pick up the digital
values ("sensor values") for each detector individually.
evaluations and "decisions" are then made in the C.U.
detectors are addressable – an address setting tool is used for detector
types 33xx and a DIL-Switch in the ASB (see below) for detectors
2xxx. An analog detector has to be plugged in an ASB.
(Analog) Sensor Base (ASB)
A sensor is plugged in an ASB, which is connected to a COM loop
(see below). Sensor Base types 2xxx have a DIL-Switch for COM
loop address setting.
Conventional detector
Detector with two states, normal or fire alarm. The detector contains a
closing contact and a series alarm resistor. Some types are plugged in
an ADB (see below) or a CDB (see below). Some types are also
available as addressable, to be connected to a COM loop (see below).
(Normally plugged in a CDB (see below), connected to a conventional
zone line with end-of-line resistor.)
Conventional Detector Base (CDB)
A conventional detector is plugged in a CDB, connected to an external
line, an addressable zone interface, conventional zone line, etc.
Addressable Detector Base (ADB)
A conventional detector is plugged in an ADB, connected to a COM
loop (see below).
8
All
Analog