Led Indicators And Push Buttons - Panasonic EBL512 Operating Instructions Manual

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748 Rev: 1
5
LED indicator
L1 Fire (5 red)
L2 Alarms queued (2 red)
L3 Extinguishing (red)
L4 Ventilation (yellow)
L5 Fire brigade tx (red)
L6 Operation (green)
Operating Instructions Fire alarm system EBL512 V2.3.x

LED indicators and push buttons

LEDs and push buttons can vary according to type and configuration
(convention / country / language).
See also Figure 2, page 14.
LED indicators on the Fire Brigade Panel (FBP)
Indicating
Fire alarm (also pre-warning, heavy smoke/heat alarm, key
cabinet alarm & co-incidence alarm
More than one unit / zone have generated fire alarm. Use
push button "Alarms queued" (P1) to scroll.
Output(s) for extinguishing equipment activated.
Output(s) for fire/smoke ventilation equipment activated.
Output for fire brigade tx (routing equipment) and/or
corresponding programmable output(s) (i.e. type 4 = routing
equipment) activated.
Test of routing equipment in progress (see menu H1).
Power on, i.e. the power supply (rectifier and/or battery are
connected and working properly.
(FBP push buttons on next page)
7
Co-incidence alarm = two-zone / address dependence.
8
L3-L5 can be individually programmed to indicate when its normal trigger
condition is met or when a programmable input is activated (e.g. L5 can be
turned on when an input is activated by a Fire brigade tx output.
16
7
)
8
8
8