Fire Alarm - Panasonic EBL512 Operating Instructions Manual

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748 Rev: 1
14.2
Operating Instructions Fire alarm system EBL512 V2.3.x
Example; pre-warning zone 123:
Pre-warning zone 123
(user definable text message)
If more than one pre-warning are generated, the LEDs "Alarms
queued" (L2) are blinking and the pre-warnings will be automatically
scrolled (each five seconds).
Pre-warning is automatically reset see chapter "Alarm reset", page 41.

Fire alarm

See also chapter "Alphanumeric display in the control unit", page 20.
According to the EN54-2 standard
following will happen:
• The buzzer in the control unit sounds 0.4 sec. each 0.4
(0.4 / 0.4 sec.).
• LEDs "Fire" (L1) are blinking (0.4 / 0.4 sec.).
• Output for routing equipment (Fire brigade tx) and outputs
type 4 = routing equipment are activated.
• Outputs for fire alarm are activated.
• In the c.i.e. display (and ext. FBP
are presented as follows.
Only one alarm point activated in a zone is presented as zone-address
(POINT: or LAST:)
Two or more alarm points activated in a zone is presented as zone
only (ZONE: or LAST:).
One alarm point
POINT: 123-45
User definable text message for 123-45
More than one alarm point in a zone
A conventional zone (zone line input)
ZONE: 123
User definable text message for zone 123
More than one zone
ZONE: 234
User definable text message for zone 234
34
Via Win512 can "Point alarm presentation" be selected (which is a
violation to the EN54-2 standard).
35
Outputs programmed for General fire alarm and outputs programmed for
the activated fire alarm(s).
36
Only the ten first fire alarms will be displayed in the ext. FBPs 2425, 2426
and 2428.
37
More than one alarm point in the same zone: If no user definable text
message is programmed, the text "Many alarms in zone" will be shown.
34
34
, in case of a fire alarm, the
35
36
display), the fire alarms
No.:001
or
No.:001
LAST: 567 No.:002
th
sec.
37