Re-Assemble Again - Felix printers Pro Series How-To
Remove stuck filament in extruder
Hide thumbs
Also See for Pro Series:
- User manual (51 pages) ,
- Quick start manual (48 pages) ,
- Troubleshooting manual (21 pages)
Advertisement
Re-assemble again.
How to remove stuck filament
8
in extruder
27 September 2019
Loosen the screw with a M2.5 screw.
Open up the assembly and remove any filament.
4 Re-assemble again.
Put back together the filament detection again.
Put back the small cover. Push the cap down while fixing it.
www.FELIXprinters.com
FELIX Pro 3
Advertisement
