Introduction - Felix printers Pro Series How-To

Introduction

1 Introduction
This manual describes how to remove stuck filament in the extruder assembly.
If you are unable to continue or have any questions, you can check at the support section of our website or you can
contact us directly:
This manual only shows the left extruder. For the right extruder it is exactly the same as they are symmetric to each
other with exception to a few details.
Website: www.felixprinters.com/support
Email: support@felixprinters.com
Telephone: +31 (0)30 30 31 387
Address: Zeemanlaan 15, 3401MV IJsselstein, The Netherlands
Kind regards,
FELIXprinters
Table of Contents
1 Introduction .............................................................................................................................................................................. 1
2 Remove cap above hot-end.................................................................................................................................................. 2
3 Take off extruder assembly .................................................................................................................................................. 3
4 Re-assemble again. ................................................................................................................................................................. 8
FELIX Pro 3
How to remove stuck filament
in extruder
27 September 2019
www.FELIXprinters.com
1