Felix printers Pro Series How-To page 10

Re-assemble again.
Slide on the filament detection back again, with spring.
Uncompress the spring again
Place back circlip
Slide the extruder assembly back again. While doing this take note of the small push arms and the lever mechanism.
Now fix the extruder again.
If you are unable to continue or have any questions, you can check at the support section of our website or you can
contact us directly:
Website: www.felixprinters.com/support
Email: support@felixprinters.com
Telephone: +31 (0)30 30 31 387
Address: Zeemanlaan 15, 3401MV IJsselstein, The Netherlands
Kind regards,
FELIXprinters
FELIX Pro 3
How to remove stuck filament
in extruder
27 September 2019
www.FELIXprinters.com
9