Real Time Transmission
When you are sending a fax, the MFC will scan originals into memory before sending.
Then, as soon as the phone line is free, the MFC will start dialing and sending the fax.
If memory becomes full, the MFC will send the document in real time (even if
TIME TX
is set to OFF).
Sometimes you may want to send an important document immediately, without
waiting for memory transmission. You can set
1
Place the original face up in the ADF, or face down on the scanner glass.
2
Press Menu, 2, 2, 6.
3
To change the default setting,
press
or
—OR—For the next fax transmission only, press
ONLY, and then press Set.
FAX
4
For the next fax only, press
Set.
5
Press 1 if you want to select additional settings. The LCD returns to the
SEND menu—OR—Press 2 if you are finished choosing settings, and then go
to Step 6.
6
Enter fax number.
7
Press Fax Start.
Checking the Jobs Status
Check memory for unsent jobs. (If no memory is clear, the LCD shows
WAITING.) (See
1
If the MFC is idle, press Menu, 2, 6.
—OR—
If the MFC is busy, press Stop/Exit.
2
If you have multiple jobs waiting, use
3
Press Stop/Exit.
Canceling a Job While Scanning the Original
You can cancel a job while you are scanning it into memory by pressing
Stop/Exit. Eject the document by pressing Stop/Exit again.
6 - 5
S E T U P S E N D
to select
ON
(or OFF), and then press Set. Go to Step 5
or
Canceling a Job in Memory
REAL TIME TX
or
to select
ON
(or OFF), and then press
, page 6-6.)
to scroll through the list.
or
REAL
to ON.
to select
NEXT
SETUP
NO JOB