Atx12V Power Supply Connector & Power Switch(Power_Sw); Hard Disk Led Connector (Hd_Led); Reset Switch (Reset) - QDI Superb 4L Manual

ATX12V Power Supply Connector & Power Switch (POWER SW)
Be sure to connect the power supply plug to this connector in its proper orientation. The
power switch (POWER SW) should be connected to a momentary switch. When powering
up your system, first turn on the mechanical switch of the power supply (if one is provided),
then push once the power switch. When powering off the system, you needn't turn off the
mechanical switch, just Push once
support ATX12V power.
Œ

Ž
Ž POWER SW
Note
Note
If you change "" POWER BUTTON OVERRIDE " " from default
"Instant-off" to "Delay 4 Sec" in the "POWER MANAGEMENT
SETUP" section of the BIOS, the power switch should be
pressed for morethan 4 seconds before the system
powers down.

Hard Disk LED Connector (HD_LED)

The connector connects to the case's IDE indicator LED indicating the activity status of IDE
hard disk. The connector has an orientation. If one way doesn't work, try the other way.

Reset Switch (RESET)

The connector connects to the case's reset switch. Press the switch once, the system
resets.
*
the power switch. Superb 4L series mainboard only
20
12V
5VSB
PS-OK
GND
5V
GND
5V
GND
3.3V
3.3V
1
GND
GND
Manual for S4L series
Installation Instructions
5V
5 V
-5V
ΠATX Power
GND
Supply Connector
GND
GND
PS-ON
GND
-12V
3.3V
 +12V Power
12V
Supply Connector
12V
7