Felix printers Pro Series Calibration Manual page 15

Coating thickness:
By adjusting the coating thickness you can bring the
nozzle closer or farther away from the bed, - brings it
closer and + moves farther.
Right extruder X offset:
Adjust the X offset to make the right head print closer
or further away from the left head the machine
calculates this and compares it to the left nozzle and
makes them print on the same level as each other. To
make it easier – is further away + is closer because the
machine will try to bring them both to the same point
so if we were to change the value of 1 with 0.05 to
make it 1.05 it would print 0.05 closer to the left
extruder than before.
Right extruder Y offset:
Adjust the Y offset to make the right head print closer
or further away from the left head the machine
calculates this and compares it to the left nozzle and
makes them print on the same level as each other. To
FELIX Pro Series
make it easier – is further away + is closer because the
machine will try to bring them both to the same point
so if we were to change the value of 1 with 0.05 to
make it 1.05 it would print 0.05 closer to the left
extruder than before.
Right extruder Z offset:
Adjust the Z offset to make the right head print higher
or lower the machine calculates this and compares it
to the left nozzle and makes them print on the same
level as each other. To make it easier – is further away
+ is closer to the bed so if we were to change the value
of 1 with 0.05 to make it 1.05 it would print 0.05 closer
than before.
11
Page