Operating Conditions; Electrical Requirements - Gfp 865DH-4 Operating Manual

5. Operating Conditions

 Place machine on level surface
 Environment requirements：
o Ambient temperature: 50⁰ F - 104⁰ F
o Humidity：30%—80%；ideal humidity：55%
 Due to the static on film rolls, you should try to keep the environment clean.
 Provide enough space around machine to ensure safe and effective operation. The
minimum area covered is 8 ft. x 10 ft.
 Do not directly cut the films on the surfaces of the rubber rollers to avoid damages to the
rollers.
 Do not put burrs, sharp knives or extra thick and hard materials in between the rollers. Do
not leave objects like tools, rulers, knives, etc. on the working panels or the side cabinets
to avoid their being pulled into the machine accidentally and damaging the rollers.
 For repairs and replacements, please contact your local dealer or distributor. Unauthorized
repairs and dismantling will affect future maintenances of the machines.
 The machine can laminate continuously objects less than ½" thick.
o For objects over ½" but less than 1" thick, use the pedal switch.

Operator should be present while machine is in operation.
Warning: Do not keep the machines in direct sunshine or near it.
Do not keep the machine in dusty place or places with strong vibrations.

6. Electrical Requirements

 220-240V 50/60 Hz Single Phase (NEMA 6-30R)
 865DH-4 – 24 amp
Connect the electrical plug, provided with the laminator, to a suitably grounded
outlet only. This machine must have reliable earth ground to ensure the safety of the
machine during operations.
 Contact an electrician should the electrical plug provided with the laminator not match
the receptacles at your location.
 Ensure that the voltages of the power supply you are using match the rated working
voltages before operations. Do not use an incorrect power supply.
 Do not use damaged wires or outlets. If abnormal conditions occur, switch off the power
supply.
Gfp 865DH-4
6
March 2021