Operating Conditions; Electrical Requirements - Gfp 865DH Operating Manual

5. Operating Conditions

• Place machine on level surface
• Environment requirements：
o Ambient temperature: 50⁰ F - 104⁰ F
o Humidity：30%—80%；ideal humidity：55%
• Due to the static on film rolls, you should try to keep the environment clean.
• Provide enough space around machine to ensure the safe and effective operation. The
minimum area covered is 8 ft. x 10 ft.
• Do not directly cut the films on the surfaces of the rubber rollers to avoid damages to the
rollers.
• Do not put burrs, sharp knives or extra thick and hard materials in between the rollers. Do
not leave objects like tools, rulers, knives, etc on the working panels or the side cabinets
to avoid their being rolled into the machine accidentally and damaging the rollers.
• For repairs and replacements, please contact your local distributor. Unauthorized repairs
and dismantling will affect future maintenances of the machines.
• The machine can laminate continuously objects less than ½" thick.
o For objects over ½" but less than 1" thick, use the pedal switch.
Operator should be present while machine is in operation
•
Warning: Do not keep the machines in direct sunshine or near it.
Do not keep the machine in dusty place or places with strong vibrations.

6. Electrical Requirements

• 220-240V 50/60 Hz Single Phase
• 24 amp
• 5760 watts
Connect the attachment plug provided with the laminator to a suitably grounded outlet only.
This machine must have reliable earth wire to ensure the safety of the machine during operations
• Contact an electrician should the attachment plug provided with the laminator not match the
receptacles at your location
• Ensure that the voltages of the power supply you are using match the rated working voltages
before operations. Do not use incorrect power supply
• Do not use damaged wires or sockets. If abnormal conditions occur, switch off the power supply
Gfp 865DH February 2018
5