Thermal Film Threading - Gfp 865DH-4 Operating Manual

17 B. Thermal Film Threading
1. Place thermal film roll on top and bottom supply shafts.
(See "Loading film" section 14)
2. Pull the top film over the top idler roller and drape down across the front Nip roller.
3. Turn the front hand-wheel counterclockwise to raise the front Nip roller.
4. Turn the rear hand-wheel to raise the rear pull.
5. Raise the feed tray assembly.
6. Pull the bottom film behind the bottom idler roller and up over the two nip rollers.
7. Using a threading board, pass the two film webs through the Nip rollers,
8. Lower the top nip roller by turning the front hand wheel clockwise until the two
rollers touch.
9. Use foot pedal to advance the film web into the Pull rollers then lower the rear
puller roller by turning the rear hand wheel clockwise until the rollers touch.
10. Lower the feed tray assembly.
11. Use foot pedal to advance both webs until cleared of the pull rollers.
12. Adjust the roller pressure on both sets of rollers to the desired position.
Warning Ensure the safety shield is in place before operating the
Laminator. Operating without the safety shield can cause serious
injury.
Gfp 865DH-4
1. Top Heat Roller
2. Linkage shaft for roller adjustment
3. Top idler roller
4. PSA film web
5. Liner rewind tube
6. Paper liner
7. PSA film roll
8. Top Rear Pull roller
9. Bottom Rear Pull roller
10. Bottom supply roll
11. Mount Adhesive
12. Bottom idler roller
13. Bottom Heat Roller
24
March 2021