Table of Contents
Advertisement
118
C H A P T E R F I F T E E N
ERROR MESSAGE
DOCUMENT JAM
INK EMPTY XXXX
MACHINE ERROR XX
MEMORY FULL
NEAR EMPTY XXXX
NO RESPONSE/BUSY
NOT ASSIGNED
PLS OPEN COVER
PRINTER JAM
SET CARTRIDGES
WARMING UP
CAUSE
Documents were not inserted or fed properly,
or document was longer than 90 cm.
One or more of the ink cartridges is out of ink.
MFC has a mechanical problem
You can't store data in the memory.
One or more of the ink cartridges is running
out of ink.
The number you dialled does not answer or
is busy.
You tried to access a One Touch or Speed Dial
number that is not programmed.
A page, piece of paper or paper clip, etc.
may be jammed inside the MFC.
The recording paper is jammed in the MFC.
An ink cartridge is not installed properly.
The print head detects low temperature.
ACTION
See Document Jam in this chapter.
Replace the ink cartridges. See
Replacing the Ink Cartridges in this
chapter.
Cut the power off. Then contact your
Brother dealer for service.
See Memory Full Message in chap. 11.
Order a new ink cartridge now.
Verify the number and try again.
Set up the One Touch or Speed Dial
number. See chap. 8.
Press the Scanner cover release button
and lift the scanner cover. If you see any
jammed paper or other item, gently pull
it out, then close the scanner cover.
If the error message remains, open and
close the scanner cover again. If the
MFC cannot reset itself and return to the
date and time prompt, it will display
MACHINE ERROR XX. Then contact
your Brother dealer for service.
See Printer Jam in this chapter.
Re-install the ink, seating it properly.
See Replacing Ink Cartridges in this
chapter.
Wait until the MFC warms up.
Advertisement
Table of Contents
