Tone/Partial/Range - Roland Aerophone Pro Parameter Manual

Tone Parameters
Parameter Value
KEY-OFF-NORMAL
Delay Mode
KEY-OFF-DECAY
Delay Time Sync
OFF, ON
Delay Time (note) 1/64T–2
Delay Time
0–1023
40
Explanation
Rather than being played while the key is
pressed, the partial begins to play once
the period of time specified in the Partial
Delay Time parameter has elapsed after
release of the key.
This is effective in situations such as when
simulating noises from guitars and other
instruments.
Delay time
Note o
Note on
Rather than being played while the key
is pressed, the partial begins to play
once the period of time specified in the
Partial Delay Time parameter has elapsed
after release of the key. Here, however,
changes in the TVA Envelope begin while
the key is pressed, which in many cases
means that only the sound from the
release portion of the envelope is heard.
Delay time
Note on Note o
Set this "ON" if you want the partial delay
time to synchronize with the tempo.
It specifies the delay time in terms of a
note value.
* This is available when Delay Time Sync
is "ON. "
It specifies the delay time without regard
to the tempo.
* This is available when Delay Time Sync
is OFF.

TONE/PARTIAL/RANGE

Parameter Value
Level
Fade Lower
Range Lower
Key Range Lower C-1–G9
Key Range Upper C-1–G9
Key Fade Lower 0–127
Key Fade Upper 0–127
Level
Fade Low
Range Lower
Velocity Range
1–127
Lower
Velocity Range
1–127
Upper
Velocity Fade Low 0–127
Velocity Fade Up
0–127
Explanation
Pitch
Fade Upper
Range Upper
Specify the key range for each partial.
Make these settings when you want
different key ranges to play different
tones.
Specify the lower limit (Lower) and upper
limit (Upper) of the key range.
Specifies the degree to which the partial
is sounded by notes played below the
Keyboard Range Low.
If you don't want the tone to sound at all,
set this parameter to "0. "
Specifies the degree to which the partial
is sounded by notes played above the
Keyboard Range Up.
If you don't want the tone to sound at all,
set this parameter to "0. "
Velocity
Fade Up
Range Upper
Specify the lower limit (Lower) and upper
limit (Upper) of the velocities that will
sound the partial.
Make these settings when you want
different partials to sound depending on
keyboard playing dynamics.
Specifies the degree to which the partial
is sounded by notes played more softly
than Velocity Range Low. If you don't
want the tone to sound at all, set this
parameter to "0. "
Specifies the degree to which the partial
is sounded by notes played more strongly
than Velocity Range Up. If you don't
want the tone to sound at all, set this
parameter to "0. "