Table of Contents
Advertisement
Parameter
Value
PMT
FXM
MFX-CTRL1
MFX-CTRL2
MFX-CTRL3
MFX-CTRL4
PW
PWM
FAT
XMOD
LFO1-STEP
Destination 1–4
LFO2-STEP
SSAW-DETN
PIT-DEPTH
FLT-DEPTH
AMP-DEPTH
XMOD2
ATT
RING-OSC1-LEV
RING-OSC2-LEV
XMOD-OSC1-LEV
XMOD-OSC2-LEV
Sens 1–4
-63–+63
Explanation
If the Matrix Control is used to split
partials, set the Velocity Control (p. 35)
to "OFF. "
5 If the Matrix Control is used to split
partials, we recommend setting the
Sens to "+63. " Selecting a lower value
may prevent switching of the partials.
Furthermore, if you want to reverse the
effect, set the value to "-63. "
5 If you want to use matrix control to
switch smoothly between partials, use
the Velocity Fade Low and Velocity
Fade Up (p. 40). The higher the
values set, the smoother the switch is
between the partials.
Changing the depth of frequency
modulation produced by FXM
Applies a change to MFX CONTROL 1–4
Source.
If this is specified for more than one
partial, the result will be the summed
values.
Applies change to PW.
Applies change to PWM.
Applies change to FAT.
This setting is valid only for the carrier
partial (Partial 1 or 3), and applies
change to the CROSS MOD 1-2 Depth or
CROSS MOD 3-4 Depth.
Specifies the step position.
In this case, the Sens value is ignored.
* This is valid when the LFO1/LFO2
Waveform (p. 45) is "STEP. "
Applies change to Super-SAW Detune.
* This is valid when the OSC Type
(p. 39) is "SuperSAW. "
Changes the depth of the PITCH envelope.
Changes the depth of the FILTER envelope.
Changes the depth of the AMP envelope.
Applies change to XMOD2 1-2 (3-4)
Depth.
* This is valid when the Structure 1-2
(3-4) (p. 36) is "XMOD2. "
Applies change to OSC Attenuator.
Applies change to RING OSC1 Level.
* This is valid when the Structure 1-2
(3-4) (p. 36) is "RING. "
Applies change to RING OSC2 Level.
* This is valid when the Structure 1-2
(3-4) (p. 36) is "RING. "
Applies change to CROSS MOD OSC1
Level.
* This is valid when the Structure 1-2
(3-4) (p. 36) is "XMOD" or "XMOD2. "
Applies change to CROSS MOD OSC2
Level.
* This is valid when the Structure 1-2
(3-4) (p. 36) is "XMOD" or "XMOD2. "
Specify the effective depth of the matrix
controls.
To make an increase in the currently
selected value (to get higher values,
move to the right, increase rates, and so
on), select a positive (+) value; to make
a decrease in the currently selected
value (to get lower values, move to the
left, decrease rates, and so on), select a
negative (-) value.
For either positive or negative value,
greater absolute values will allow greater
amounts of change.
Set this to "0" if you don't want to apply
the effect.
Tone Parameters
49
Advertisement
Table of Contents
