Disassembling The Fan Assembly - Technogym spin trainer Maintenance Manual

SPIN TRAINER: Service & Maintenance Manual - rev. 2.0
7.7.

DISASSEMBLING THE FAN ASSEMBLY

Figure 7.7-1
Figure 7.7-2
Figure 7.7-3
Carry out the procedure described in paragraph
7.1. "Disassembling the display".
1. Disconnect connector K3 from the fan
control board.
2. Unscrew the 2 self-tapping screws a using a
large Phillips screwdriver.
3. Remove the rear cover b of the display.
4. Remove the fan cable.
5. Unscrew the 4 screws c fixing the instruction
lexan d to the FAN ASSEMBLY bracket.
6. Unscrew the left-hand bracket e of the FAN
ASSEMBLY using a 5-mm hex T-wrench.
7. Cut the strap fixing the FAN cable on the
protective grill.
8. Remove the protective grill from the FAN
ASSEMBLY.
9. Remove the FAN.
To reassemble the FAN GROUP, carry out the
above procedure in reverse order.
Page 7.7