Version B:
Figure 7.17-2
Page 7.18
SPIN TRAINER: Service & Maintenance Manual - rev. 2.0
1. Turn off the machine and unplug the mains
lead from the wall outlet.
2. Disassemble the bicycle fork clamp f.
3. Remove circlip g using the circlip pliers.
4. Pull out pin h.
5. Unscrew screw l using a 5-mm hex T-
wrench.
6. Working through the slot in support i, use a
pointed tool to push out the 2 SHOCK
ABSORBERS, knocking against the edges.
To reassemble the SHOCK ABSORBERS, carry
out the above steps in reverse order.
Always reassemble the steel wool to
ensure grounding of the bicycle frame.