The Machine Does Not Print - Technogym spin trainer Maintenance Manual

6.7.

THE MACHINE DOES NOT PRINT

THE MACHINE
DOES NOT
PRINT
Is the machine correctly configured for
printing?
YES
Does the signal reach the output of
the printer cable correctly?
NO
Is the printer cable OK?
NO
Replace or rewire the printer
cable
Follow the procedure step by step to correctly diagnose the problem. Take particular care with the
checks highlighted by the circled numbers, which are described in detail below:
(1) Open the display and configure the 4 dip-switches as detailed in paragraph 9.1. .
(2) To perform this check, use the RS-232 tester:
Page 6.16
SPIN TRAINER: Service & Maintenance Manual - rev. 2.0
1
NO
Correctly configure the
machine: see paragraph 9.1.
2
YES There is a problem with the
printer or the PC serial port
or their respective
configurations
3
YES
Is cable SP-8 between the serial
connector and the CPU board OK?
NO
Replace or rewire cable SP-8
4
Replace the CPU board: see
paragraph 7.4.
YES