Turning The Pump On/Off; Resetting The Reservoir Volume - CADD Legacy Plus 6500 Operator's Manual

Section 3: Operating the Pump

Turning the Pump On/Off

When the pump is stopped, you may put the pump into a low power state
by turning it off. The pump may be turned off when it is disconnected
from the patient and it is going to be stored for short periods of time.
CAUTION: Do not store the pump for prolonged periods of time with
the batteries installed. Battery leakage could damage the pump.
To turn the pump off
• Press and hold
Three sets of dots will appear one-by-one on the pump's display,
each accompanied by a single beep.
To turn the pump on
• Press and hold
review all screens.

Resetting the Reservoir Volume

To reset the Reservoir Volume to the value programmed in LL0, the
pump may be in any lock level.
1. Stop the pump.
„
2. Press to display the Reservoir Volume screen.
¤
3. Press to reset the volume to the programmed value.

Å .
Å . The pump will power up and automatically