Table of Contents
Advertisement
4. Place the battery door over the battery compartment and slide the
door closed.
5. Ensure that the door is latched by trying to remove the door with-
out pressing the arrow button.
NOTE: The power-up sequence will start, the pump will go through
an electronic self-test, and the pump will beep 6 times at the end of
the power-up sequence. All of the display indicators, the software
revision level, and each parameter will appear briefly.
Section 2: Pump Setup and Programming
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Legacy Plus 6500 and is the answer not in the manual?