Philips EM6E Service Manual page 37

Phenomenon Possible Cause
Problems with NexTView
Problems caused by
EPG (Electronic EPG broadcasts.
Program Guide).
The TV set "hangs".
NexTView EPG is EPG version 2C3 is
not functioning only switched off during pro-
Teletext guide. duction.
Error codes of devic- When there are errors on
es on slow I2C bus. the slow bus it is possible
that the TDL interface,
DVD or radio module
caused them.
Various symptoms, An interrupted fuse, NFR-
due to missing local resistor or connection.
supply voltage.
5.9
Software Downloading
In this chassis, you can upgrade the software via ComPair. You
can find more information on how this procedure works in the
ComPair file. It is possible that not all sets are equipped with
the hardware, needed to make software upgrading possible. To
speed up the programming process the firmware of the
ComPair interface can be upgraded. See paragraph "How To
Order" for the order number
Service Modes, Error Codes, and Fault Finding
Repair tip
To switch from EPG 2C3 to Teletext guide. Press for 4 seconds, simultaneously the Menu
button on the TV and digit 0 on the remote. The option settings for NexTView type and
Flashram will not change.
To switch from Teletext guide to EPG 2C3. Press for 4 seconds, simultaneously the Menu
button on the TV and digit 1 on the remote. The option settings for NexTView type and
Flashram will not change.
When you clear the error buffer and do a functional test. Make sure you activate all modes
available: TV, DVD and Radio in the user menu. By doing this all modules are activated and
tested and possible error codes are logged. Another option is: You disconnect the flat cable
(connector 1250) on the interface board TDL (T) to pinpoint where the problem is located
on the slow bus.
When no symptom or error code leads you to a specific circuitry, use the supply lines over-
view (see supply lines overview), for a quick scan of all supply lines.
EM6E AB 5. EN 39