Table of Contents
Advertisement
EN 26
4.
EM6E AB
switch mounting later on. Each micro switch has a small
protuberance that should fit in a positioning hole.
Figure 4-8 Micro switch mounting.
Motor mechanism screws
Figure 4-9 Motor mechanism screws.
1. Unscrew both motor mechanism mounting screws.
2. Remove the cable connector [1207], motor cable
connector [1201] and both micro-switch connector cables
[1204 and 1203] and next, remove the mechanism.
Remove the Top LCD panel assy
Hinge pin
Figure 4-10 Toothed lever and hinge pins.
1. Fold out the LCD panel to gain access to the hinge pins.
2. Shift at both sides the hinge pins away to release the LCD
panel hinges.
3. Remove the screw that secures the toothed lever to the
LCD panel, see figure.
Mechanical Instructions
Positioning hole
Protuberance
CL36532008_134.eps
130503
CL36532008_132.eps
120503
Toothed lever screw
CL36532008_133.eps
120503
4. Remove the flat cable and next, remove the LCD panel
assy.
4.4
Side-I/O Assy / Panel
Figure 4-11 Side I/O assy.
1. Release the snap-hook [1] with your finger.
2. At the same time, pull the assy backwards [2].
3. Release the two fixation clamps on the right side of the
bracket (the board hinges at the left side).
4. Remove the board from the bracket.
4.4.1
Mains Switch Assy / Panel
1
2
Figure 4-12 Mains Switch Assy.
1. Release the two fixation clamps by pushing them upwards
[1]. At the same time, pull the complete assy backwards [2].
Note: be aware that the degaussing coil/cable can hamper
this.
1. Release the two fixation clamps on the two sides of the
bracket (the board hinges at the connector side).
2. Remove the board from the bracket.
3. When the light guide (sitting in the cabinet, in front of the
LEDs) is defective, you can replace it by pushing it
forwards at the left side (it hinges at the right side, seen
from the rear).
3
2
2
1
CL 16532149_069.eps
061201
1
CL 16532149_070.eps
061201
Advertisement
Table of Contents
