Brother DCP-6690CW Network User's Manual page 78

Wireless Configuration for Macintosh
m
If the LCD shows Connected, the machine has successfully connected to your router or access point.
You can now use your machine in a wireless network.
If the LCD shows Setting WLAN, Connecting WLAN, then Connection Failed, the machine has
not successfully connected to your router or access point. Try starting from j again. If the same
message is indicated again, reset the machine back to the default factory settings and try again. For
resetting, see Restoring the network settings to factory default on page 112.
If the LCD shows Setting WLAN, then Connection Failed or Incorrect Mode, session overlap
is detected (see the table below). The machine has detected more than one router or access point on
your network that has the Wi-Fi Protected Setup™ mode or AOSS™ mode enabled. Make sure that only
one router or access point has the Wi-Fi Protected Setup™ mode or AOSS™ mode enabled and try
starting from j again.
LCD messages when using the SES/WPS/AOSS control panel menu
LCD shows
Setting WLAN
Connecting SES
Connecting WPS
Connecting AOSS
Connected
Connection Failed
Incorrect Mode
n
Click Finish.
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Start Here OSX from the CD-
ROM menu.
®
using the Brother installer application (Not available for MFC-5490CN and MFC-5890CN)
Connection status
Searching or accessing the access point, and
downloading settings from the access point.
Connecting to the access point.
Connection succeeded.
Connection failed.
(If this is shown after the LCD shows
Connecting SES, Connecting WPS or
Connecting AOSS.)
A session overlap was detected.
A session overlap was detected.
Action
—
—
—
1 Try starting j again.
2 If the same message continues,
reset the machine back to the factory
settings and try again.
Check that only one router or access
point has the Wi-Fi Protected Setup™
mode or AOSS™ mode enabled and try
starting from j again.
5
68