Operating Mode Checks; Figure 4-3: Cont Mode Initial Test Hookup - Sony Tektronix AWG2021 Service Manual

Performance Tests

Operating Mode Checks

Check Cont Mode
4-12
These procedures check operation of the Cont, Triggered, Burst, Gated,
Waveform Advance, and Autostep modes.
Electrical
Operating mode, Continuous, on page 1-4.
Characteristic
Checked
Equipment One 50 W coaxial cable
Required
One oscilloscope
Prerequisites The AWG2021 must meet the prerequisites listed on page 4-7.
1. Install the test hookup and set test equipment controls:
a. Hook up the oscilloscope: Connect the AWG2021 CH1 output connector
through the coaxial cable to the CH1 vertical input connector on the
oscilloscope (see Figure 4–3).
AWG2021
AWG2021

Figure 4-3: Cont Mode Initial Test Hookup

b. Set the oscilloscope controls:
Vertical . . . . . . . . . . . . . . . . . . . . . .
CH1 coupling:
CH1 scale . . . . . . . . . . . . . . . . .
CH1 input impedance:
Horizontal
Sweep . . . . . . . . . . . . . . . . . . . .
Trigger
Source . . . . . . . . . . . . . . . . . . .
Coupling . . . . . . . . . . . . . . . . . .
Slope . . . . . . . . . . . . . . . . . . . .
Level . . . . . . . . . . . . . . . . . . . .
Mode . . . . . . . . . . . . . . . . . . . .
Oscilloscope
TDS 540
CH1
. . . . . . . . . . . . . DC
0.2 V/div.
50 W
. . . . . . .
500 ms/div.
CH1
DC
Positive
+100 mV
Auto
AWG2021 Service Manual