Equipment Required; Before Adjustments; Providing Access; Table 5-1: Test Equipment - Sony Tektronix AWG2021 Service Manual

Adjustment Procedures

Equipment Required

Table 5-1: Test Equipment

Item Description
BNC cable
PELTOLA cable with BNC
connector*
Test oscilloscope
Digital multimeter
Fan
* The PELTOLA cable with BNC connector is included in the maintenance kit (Tektronix Part 067 1396 01).

Before Adjustments

Providing Access

5-2
Table 5–1 lists the test equipment required to adjust the AWG2021.
Minimum Requirements
Impedance: 50 W
Connectors: BNC
Length: 43 inches
Must use example equipment
Bandwidth: >250 MHz
DC volts range: 0.05 V to 5 V
Accuracy: ±0.1%
The following instructions describe preparing the AWG2021 for adjustment,
loading the adjustment file required for these procedures, and making
adjustments.
CAUTION. To avoid damaging the eject button, make sure a floppy disk is NOT in
the floppy disk drive before removing the cabinet.
Before doing the adjustments, remove the AWG2021 rear cover and cabinet. See
section 6, Maintenance, for instructions on removing the cabinet and replacing it
after adjustment is done.
Example
Tektronix Part 012 0057 XX
Tektronix Part 131 1315 XX
Tektronix TDS500 Series Digitizing
Oscilloscope or 2400 Series Digitiz
ing Oscilloscope
Fluke 8842A Digital Multimeter
Purpose
Signal interconnection
Signal interconnection
Used to check output
signals
Used to measure voltage
Used to cool the
AWG2021
AWG2021 Service Manual