Performance Check/Adjustment Files - Sony Tektronix AWG2021 Service Manual

Table 4-1: Test Equipment (Cont.)
Item Description
Frequency counter
Digital multimeter
Function generator
Power supply
(Option 03)
Performance Check/Ad
justment disk
* Requires a TM 5000 Series Power Module Mainframe

Performance Check/Adjustment Files

AWG2021 Service Manual
Minimum Requirements
Frequency range: 10 Hz to 250 MHz
DC volts range: 0.05 V to 5 V
Accuracy: ±0.1%
Output voltage: -5 V to 5 V
Output voltage: -2 V
Must use example listed
Table 4–2 lists the waveform files on the Performance Check/Adjustment disk
(063-2171-XX) that are used in these performance test. It describes the
AWG2021 front-panel settings that each file sets up, and the performance test
that uses each file.
NOTE. The files on the Performance Check/Adjustment disk are locked (the files
names are displayed with *), so the data in these files cannot be changed unless
the lock is opened. The file data includes not only waveform data, but also
output parameters.
When you select a file with the Waveform Sequence item, the AWG2021 output
parameters change to those specified in the file, and the waveform output
reflects waveform data in the file. After selecting a file, do not change an output
parameter with the SETUP menu unless a procedure instructs you to do so.
During the procedures, if you are unsure that the AWG2021 settings still match
the file's settings, select the waveform again using the Waveform Sequence item
on the SETUP menu.
Example
Tektronix DC 5010 Programmable
*
Universal Counter/Timer
Fluke 8842A
Tektronix FG 5010 Programmable
*
Function Generator
Tektronix PS 2510 Programmable
Power Supply
Tektronix Part 063 2171 00
Performance Tests
Purpose
Used to check clock
frequency.
Used throughout the
checks to measure
voltage.
Used to input the trigger
signal.
Used to check ECL digital
data output.
Used throughout the
checks to provide
waveform files.
4-9