Line Fuse And Line Cord - Sony Tektronix AWG2021 Service Manual

Line Fuse and Line Cord

(3) Pull
Figure 6-6: Line Fuse and Line Cord Removal
AWG2021 Service Manual
1. Assemble equipment and locate modules to be removed: You will need a
flat-bladed screwdriver to do this procedure. Locate the line fuse and line
cord in the locator diagram, External Modules, Figure 6–3.
2. Orient instrument: Set the AWG2021 with the bottom down on the work
surface and the back facing you. If you are servicing the line fuse, do the
next step; if you are servicing the line cord, skip to step 4.
3. Remove line fuse: Find the fuse cap on the rear panel. See Figure 6–6. Now,
remove the fuse cap by turning it counter-clockwise using a flat-bladed
screwdriver, and remove the line fuse. Reverse the procedure to reinstall.
4. Remove line cord: Find the line cord on the rear cover. See Figure 6–6. Now,
remove the line-cord retaining clamp by first unplugging the line cord from
the line cord receptacle (1). Next, grasp both the line cord and the retaining
clamp and rotate it 90 degrees, counter-clockwise (2). Pull the line cord and
clamp away to complete the removal (3). Reverse the procedure to reinstall.
5. Reinstallation: Do steps 3 and 4 in reverse order to reinstall the line cord,
and then the line fuse.
Line Fuse
Fuse Cap
Removal and Installation Procedures
(2) Rotate
(1) Unplug
6-17