Power Supply Module - Sony Tektronix AWG2021 Service Manual

Power Supply Module

AWG2021 Service Manual
Disconnect
Rear BNC
Connector
Figure 6-17: Rear BNC Connector Removal
1. Assemble equipment and locate modules to be removed: You will need a
screwdriver with a size T-15 TorxR tip to do this procedure. Locate the
modules to be removed in the locator diagram, Internal Modules, in
Figure 6–4.
2. Orient instrument: Set the AWG2021 with the bottom down on the work
surface and the left side facing you.
3. Remove power supply module:
a. Disconnect the ribbon interconnect cable at J1, J3, J4, and J5 on the
power supply module. See Figure 6–18.
b. Disconnect the flat cable at J2 on the power supply module.
c. Using a screwdriver with a size T-15 TorxR tip, remove the two screws
attaching the power supply module to chassis.
Removal and Installation Procedures
6-35