US TYPE: PAD02-2
Please make sure that the intensity of the screw lampholder of the electrical
Note:
device must be Maximum Load (Ampere) and have same head as the enclosed
screw lampholder before inserting to the socket.
Troubleshooting
Symptom
Cause of Failure
The dimmer does not
1.The dimmer is not
work and LED off
plugged into the electrical
outlet properly
2.The dimmer break down
The dimmer LED
Check if the load plugged
illuminating, but cannot
into the dimmer has its
control the ON/OFF
own ON/OFF switch
dimmer of the load
attached
The dimmer LED
1. Not carry out association
illuminating, but the
2. Same frequency
detector cannot control
interference
the dimmer
Specification
Operating Voltage
100V~240V / 50Hz~60Hz
Maximum Load (Ampere) 1A (Resistive load); ( PAD02-1; PAD02-2)
Maximum Load (Ampere) 0.1A (dimmable led bulbs) ; ( PAD02-1; PAD02-2)
Screw lampholder Type:
EU type: E27 to E14; PAD02-1
US type: E26 to E12; PAD02-2
Range
Minimum 40 m in door 100m outdoor line of sight
Operating Temperature
0° C ~ 40° C
Frequency Range
868.40MHz & 869.85MHz/ EU (PAD02-1);
908.4MHz & 916.0MHz/ USA (PAD02-2);
** Specifications are subject to change and improvement without notice.
FCC ID : RHHPAD02
5
Recommendation
1. Check power connections
2. Don't open up the dimmer and send it for
repair.
Set the ON/OFF switch of the load attached
to ON
1. Carry out association
2. Wait for a while to re-try