Advertisement
Reset
1. Pressing Include button of PAD02
three times within 2 seconds will
enter inclusion mode.
2. Within 1 second, press Include button
of PAD02 again for 5 seconds.
3. IDs are excluded.
1.
The PAD02 is an always listening
Association
Z-Wave device, so associations may
be added or removed by a controller
at any time.
Or If your controller requires to have
the PAD02 send a 'node information
frame' or NIF for associations, then
pressing the On/Off button three
times within 2 seconds will cause
the PAD02 to send its NIF.
2. There are only two groups for the
switch
Adding a node ID allocated by Z-Wave Controller means inclusion. Removing a node
ID allocated by Z-Wave Controller means exclusion.
Failed or success in including/excluding the node ID can be viewed from the Z-Wave
Controller.
LED Indication
To distinguish what mode the switch is in, view from the LED for identification.
State Type
LED Indication
Normal
Whenever we switch On and off of the PAD02 by On/Off button or
RF command, the LED will lights up when switch on; whereas LED
off when switch off.
No node ID
Under normal operation, when the dimmer has not been allocated a
node ID, the LED flashes on and off alternately at 2-second intervals.
By pressing On/Off button, it will stop flashing temporarily.
Learning
When PAD02 is in learning mode, LED flashes on and off alternately
and repeatedly at 0.5 second intervals.
Choosing a Suitable Location
Use this procedure only in
1. Do not locate the dimmer facing direct sunlight, humid or dusty place.
the event that the primary
controller is lost or otherwise
2. The suitable ambient temperature for the dimmer is 0°C~40° C.
inoperable.
3. Do not locate the dimmer where exists combustible substances or any source of
0.5s On, 0.5s Off (Enter
auto inclusion)
4. After putting it into use, the body of dimmer will become a little bit hot of which
Manual dim level control :
To manually switch on the light, press and release the On/Off button shortly when the
light is off. The light will dim from off to the level which was set before switch off. To
manually switch off the light, press and release the On/Off button shortly when the
light is on. To adjust the dim level, press and hold the On/Off button until the desired
dim level is achieved, then release.
Programming :
1. Basic Command Class / Multilevel Switch Command Class
Basic Get Command: [Command Class Basic, Basic Get]
Basic Report Command:
Report OFF: [Command Class Basic, Basic Report, Value = 0 ]
Report ON:[Command Class Basic, Basic Report, Value = 1~99 ]
Basic Set Command:[Command Class Basic, Basic Set, Value = 1~99 ]: the light
attached to the dimmer turns on.
2
heat, e.g. fires, radiators, boiler etc.
phenomenon is normal.
The dim level can be set by BASIC and MULTILEVEL SWITCH commands.
1-1 BASIC_GET
Upon receipt of the following commands from a Z-Wave Controller, the dimmer
will report its dim level to the node inquired.
1-2 BASIC_SET
Upon receipt of the following commands from a Z-Wave Controller, the dimmer
will be set to the dim level.
Advertisement
