Maxwell AutoAnchor 560 V2 Owner's Manual page 9

2.1.7 INSTALLATION VERTICAL WINDLASS - ROPE & CHAIN
Refer to the Overview Notes on page 3 before starting installation.
For an accurate rope and chain count, the rode must run between the sensor and
Chainwheel
Magnet Size:
used on smaller windlasses. Check with your supplier.
Magnet Fit:
Sensor Position
so that the rode passes between the sensor and the magnet. The centre of the magnet
gap between the sensor and magnet must be as per the table below.
Gap Between the Sensor and Magnet
Sensor Position Rope & Chain Vertical Windlasses
Range
Locker
Chainwheel
o
90
Bow
Gap
Sensor Connection: The AutoAnchor
must be used to connect the sensor
to the console unit. Ensure the
Loose cable should be tied in place
with cable ties and kept clear of
chain.
Rode
Fig 4