Maxwell AutoAnchor 560 V2 Owner's Manual page 29

OTHER TROUBLESHOOTING
1. AutoAnchor beeps when it is turned off or
locked.
not turning or counts erratically displaying a
large number. The screen may display Sensor
unstable and the unit may beep when turned off
or locked.
because total rode length is set to OFF.
4. The count pauses during retrieval.
This applies to rope/chain rode only.
deployed and counts out when rode is retrieved.
pressed.
point.
AFTER ANY SENSOR REPAIRS OR CHANGES:
DOCK THE ANCHOR AND RESET THE SENSOR. SEE PAGE 24.
FOR ADDITIONAL TROUBLESHOOTING:
Contact AutoAnchor support
POSSIBLE CAUSE/ACTION
1. The unit beeps when it receives a sensor
pulse. This could be because the windlass
is being controlled by a means other than the
AutoAnchor. This is not an error.
1. Uncontrolled anchor rode could be running
through the windlass or there may be some
may be faulty.
plug is not used the wires must be soldered. All
wires must be connected (including the drain)
and shielded cable must be used.
Total length of rode has been set to off.
Motor disabled AutoAnchor then operates as a counter only.
If the sensor indicator (arrow) is still pulsing, this
is not a fault. The rode is changing from rope
to chain.
The unit is not receiving correct direction
swapped.
1. The motor or solenoid wiring is reversed.
Change the wiring and check the direction of
windlass rotation. If the brown and white wires
are connected, also check that they are correct
after you have changed the wiring.
revolution. The chainwheel will run on slightly
with momentum.
Using the Automatic function the rode release