Maxwell AutoAnchor 560 V2 Owner's Manual page 26

4.3 OTHER OPERATION SETTINGS
Press to access the menu when the AutoAnchor is turned on.
4.3.1 To Clear to Zero
The AutoAnchor must be turned on.
Yes - return to start screen.
No - return to the menu, then press
to return to the start screen.
4.3.2 To Check Logs
The AutoAnchor must be turned on.
Return to the menu.
Resetting the Factory Defaults clears all logs and calibrations.
4.3.4 To Adjust Backlight
The AutoAnchor must be turned on. It is best to change this setting in low light.
4.3.5 To Reset Sensor
The AutoAnchor must be turned on.
again
Reset sensor
Reset sensor
Logs
Reset sensor
9
10742
112
Reset sensor