Part 5 Maintenance; Part 6 Troubleshooting - Maxwell AutoAnchor 560 V2 Owner's Manual

PART 5 MAINTENANCE

The AutoAnchor does not contain any user servicable parts.
necessary.
magnet and replacing the sensor if necessary. After any sensor repairs or changes to
sensor installation reset the sensor. See Page 24.
it with a clean damp cloth. Avoid wiping the display screen with a dry cloth as this could
scratch the screen.

PART 6 TROUBLESHOOTING

troubleshooting. These messages are designed to assist the user. They may be
information messages
They may also be diagnostic messages
compatible or the power supply is wired incorrectly.
information on the following pages.
Please Note: Th
caused by a fault with the AutoAnchor.
TROUBLESHOOTING
MESSAGES
1. Auto mode disabled
Note: Unless the fault is
in the solenoid wiring the
AA560 will operate the
windlass in manual mode
when this message is
displayed.
operate windlass.
The voltage displays on the
status bar.
POSSIBLE CAUSE/ACTION
1. If the battery is fully charged, check the wiring for bad
connections.
below.
ipe
They are not