Maxwell AutoAnchor 560 V2 Owner's Manual page 12

2.2 CONSOLE INSTALLATION
Choose a position where the operator will be able to see the anchor and windlass when
bolts are supplied. These should be hand tightened only.
2.2.1 MULTIPLE CONSOLE INSTALLATION
can also be installed with other windlass control stations eg foot switches, remote controls
are uncertain how to proceed contact your supplier.
2.3 POWER SUPPLY
THE POWER SUPPLY MUST BE DISCONNECTED WHEN INSTALLING,
CONNECTING OR CHANGING THE WIRING
12V or 24V DC power supply is required.
Check battery polarity before connecting power.
Amps). An additional isolating switch should be installed for controls if the main breaker or
isolator is not readily acessible from the helm.
become the common negative return (ground).
windlass controls eg. toggle switch, remote switches, deck switches, other AutoAnchor
devices. Power supply must not be from the motor positive near the windlass.
for details. If you