Maxwell AutoAnchor 560 V2 Owner's Manual page 8

2.1.6 INSTALLATION VERTICAL WINDLASS - CHAIN ONLY
Refer to the Overview Notes on page 3 before starting installation.
Magnet Size:
Magnet Fit
in the underside of a spoke in the bottom of the chainwheel. Cover the magnet with a
Sensor Position:
per the table below.
Gap Between the Sensor and Magnet:
Sensor Connection:
Loose cable should be tied in place with cable ties and kept clear of chain.
Chainwheel
Fig 1 - All sensors
Note: If it is not possible to
align the sensor and magnet
alignment. The AA black sensor
and the reed switch sensor must
be directly aligned.
Gap