Maxwell AutoAnchor 560 V2 Owner's Manual page 31

Sensor Installation Diagnostic Messages
Red sensor wire
grounded
not compatible with
rope and chain set-
tings.
Other Diagnostic Messages
disconected
disconected
Load wires
If no short is found, the sensor may be damaged. Try a new sensor.
Windlass will operate but not count.
are being received by the console and it is not counting.
Rotate the windlass to check for signal voltage. If there is still no signal
either the magnet or the sensor needs replacing. Check the magnet is
strong and not rusted and check the sensor for physical damage.
with this selection.
Possible causes:
The sensor is not the grey AA sensor.
The windlass has been operated with no chain so the tuning is incorrect.
Possible Causes and Solutions
Check the solenoid wires are properly connected.
terminal.
These wires are used for combination rope and chain rodes. They are
not required for chain only use.
volts at idle. Under load they show motor ground and supply terminal voltages.
The voltage at the time of failure is recorded on the status bar.
The power supply wiring has high resistance or is too thin for the distance of
the run or the ground wire is disconnected.
input (all chain) instead of
-