Windlass; 4.2 User Precautions - Maxwell AutoAnchor 560 V2 Owner's Manual

4.2 USER PRECAUTIONS

should be allowed to use the AutoAnchor to control this equipment;
disconnect the windlass/winch from all power sources in the event of an
emergency;
use;
When Controlling a Windlass/Winch
4.3 SET UP AND TESTING
and then tested in a safe environment. The AutoAnchor will not count correctly if the
windlass selection is wrong or the windlass is not standard (eg it is installed with a different
chainwheel or motor).
4.3.1 PLUG & PLAY SENSOR TUNING
a loss of sensor signal.
Installation and set up must be complete and the anchor must be
docked before starting this process.
display "Sensor tuning". Continue deployment until this message
changes to "Tuning done". This must be done in one continuous
"Tuning done" message displays. This could take up to 10 turns
of the windlass. Retrieve the anchor to the docked position and clear
process again.
Rope/Chain Systems: The default rode set up is chain only. If rope
and chain rode is selected without the correct sensor and magnet set
message will display. Check the installation and rode set up and reset
the sensor to restart the tuning process.
ty to ensure the AutoAnchor is installed, used and
rding to the manufacturer's instructions;
docked and secured before moving the boat.
loaded, the sensor is reset or there has been
the button, start the