Maxwell AutoAnchor 560 V2 Owner's Manual page 11

2.1.9 INSTALLATION HORIZONTAL WINDLASS - ROPE & CHAIN
Before starting check with the AutoAnchor manufacturer, or supplier, that it is
For an accurate rope count the rode must run between the sensor and m
If it is not possib
rode deployed but during retrieval the display may be incorrect because it cannot
allow for the stretch in the rope.
2.1.10 INSTALLATION DRUM WINCHES
Gap Between the Sensor and Magnet:
winch turns.
Magnet Installation:
The magnet can be mounted on the m
completely sealed to prevent corrosion
Sensor Installation
be used. Every installation is different so this manual can provide guidelines only. The AA
sensor remains in position and the gap is consistent between the sensor and magnet
during operation.
Sensor Connection:
Loose cable should be tied in place with cable ties and kept clear of chain.
For drum winch set up and operation, refer to page 19.
Fig 7
d so that the gap remains consistent as the
.
This provides an accurate count of
on shaft
on side of
drum