Renesas E2 Lite User Manual page 21

E2 Lite
(2) A connector to the user-system interface cable must be installed on the user system. Table 2.1 shows the
recommended connector for the emulator.
Table 2.1 Recommended Connector
Connector
14-pin (2.54-mm
pitch) connector
20-pin (1.27-mm
pitch) connector
10-pin (1.27-mm
pitch) connector
10-pin (1.27-mm
pitch) connector
Note: When using the connector without a guide marking, take care regarding the direction for insertion of the cable.
(3) For the pin assignments of the connector, refer to the additional document for user's manual for the
E1/E20 emulator or E2 emulator Lite which corresponds to the target MCU.
(4) Connect one end of the user-system interface cable to the E2 Lite and the other end to the connector on
the user system as shown in Figure 2.3 and Figure 2.4.
Figure 2.3 Connecting the User-System Interface Cable to the 14-Pin Connector when the E2 Lite is
User-system interface cable with the 20-pin
(1.27-mm pin pitch) connector
Pin 2
Pin 1
Figure 2.4 Connecting the User-System Interface Cable to the 20-Pin Connector when the E2 Lite is
R20UT3240EJ0300 Rev.3.00
May.15.20
Type Number
7614-6002
2514-6002
FTSH-110-01-L-DV-K
FTSH-105-01-L-DV-K
FTSH-105-01-L-DV*
(no guide marking)
14-pin user-system interface cable
Pin 2
Pin 1
to be Used
to be Used
Manufacturer
3M Japan Limited 14-pin straight type (Japan)
3M Limited 14-pin straight type (other countries)
Samtec 20-pin surface-mount straight type
Samtec 10-pin surface-mount straight type
Samtec 10-pin surface-mount straight type
14-pin connector
7614-6002 or
2514-6002
User system
Connector:
20-pin (1.27-mm pin pitch) connector
Samtec type number: FTSH-110-01-L-DV-K
User system
Setup
Specifications
Page 21 of 36