Advertisement
OPEARATING INSTURCTIONS AND PARTS MANUAL
STEP 1 - VERIFY PACKAGE CONTENTS
STAINER BASE
DISCHARGE
STEP 2 - CONNECT GARDEN HOSE
STEP 3 - PLACE IN WATER
POWER CORD
HANG LOOP
CARRYING
HANDLE
REQUIRES 1-5/8" OF WATER
TO START PUMPING
REMOVES WATER DOWN TO
1/2" OF SURFACE
FEED ROPE THROUGH
LOOP ON HOUSING AND
SECURE WITH KNOT
STEP 5 - PLUG INTO GFCI OUTLET
DESCRIPTION
This portable, Auto On-Off Submersible Mult-Use Pump is designed
for automatic removal of water. The units are equipped with a 10 ft.
3-prong grounding type power cord and its 3/4 in. adapter can be
used for convenient attachment to a standard garden hose.
APPLICATION AND OPERATION
PUMPING HEIGHT
When water is pumped to an elevated position, any volume that has
not reached the discharge outlet can flow back through the pump
when the pump shuts off. This back-flow can cause the water level in
small areas to rise enough to re-start the pump.
1. This pump has been designed with a 3/4" garden hose discharge
connection. Thread the female end of the garden hose to the
male end of the garden hose adapter.
2. Use a hose washer (not included) on the garden hose for correct
pump operation.
3. For best pump performance, unwind the hose before starting the
pump. This will help remove any kinks or binds in the hose and
allow the unit to pump with less restriction.
4. With pump unplugged set the pump where water will collect. Do
not set the pump directly on mud, sand surfaces or in leaves. For
best results make sure the strainer base is making full contact
with a clean area. This will allow the strainer to properly filter
debris and help prevent clogging of the pump. If necessary clear
an area before placing the pump.
5. The water level must be at least 5/8 inches for the pump to prime,
and operate. Water levels less than 5/8 inches will not allow the
pump to prime, therefore no water will be moved.
6. Plug the pump into a properly grounded 120 volt GFCI protected
outlet. If the water level is greater than 5/8 inches the pump
will start once plugged in. A priming delay of 2 seconds is
programmed into the control to allow time for air to escape from
the pumping chamber.
5
Advertisement
