Set System Time (Only Used In Clock Mode) - AERMEC WRC1 User Manual

EN

Set system time (only used in CLOCK mode):

To set the time on the system clock (only used if CLOCK mode is selected in the operating parameters, parameter P33), perform
the following operations:
(1)
press and hold down the "TIMER" button (5 seconds); at this stage, the symbol ( ) appears will fl ash to indicate that
system time modifi cation mode has been selected;
(2)
press the ( ) or (
(3)
press the "TIMER" button again or the "SWING/ENTER" button to save the time and exit the procedure;
(1)
(3)
54
) buttons, respectively to decrease or increase the clock by 1 minute;
x 5 seconds
(2)
the icon begins
to fl ash