Camera Control - Reach Bee7 User Manual

REACH Bee7
l
User Manual
corresponding video signals can be displayed normally, you need to choose Standard
definition for Input 1 and High definition for Input 2.
Choose a respective signal standard for Input 1 and Input 2 according to the
1
interface connection type, as shown in Figure 3-6.
Click Save and a dialog box "Save success!" is prompted.
4.
Bee 7 will reboot automatically after Click OK and then complete the setting.
5.

3.2.2 Camera Control

Uploading a PTZ protocol
Click Camera Control to open the parameter setting page, as shown in Figure 3-7.
If there is no suitable camera control protocol for the existing camera, you need to
upload an appropriate one. Note: Changing the input setting will lead to system
reboot. You are recommended to stop recording first.
F i gu r e 3 - 6
F i gu r e 3 - 7
All Rights Reserved © SZ REACH TECH CO., LTD. 14