Table of Contents
Advertisement
HEAD
WARNING:
Dispose of hydraulic oil in accordance with all environmental regulations applicable in your area.
Remove nose assembly from tool before attempting disassembly of head assy.
Remove end cap (731417). Push against threaded end of piston (731211) to slide it out of head cylinder (731298). Be careful not to
damage threads or cause burrs on polished piston (731211) surface.
The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply Loctite® #242 and torque
the four button-head cap screws (A-928) uniformly to 40 inch lbs. to prevent leakage around the gasket (704129).
GB731 S/N: 1702 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
731134 - BACK-UP RING
(2 REQ'D)
731139 - SCREW-
PISTON ROD CAP
PISTON ROD ASSY (731333)
10
REV. 3/15
Advertisement
Table of Contents
