Replacing the Speed Sensor
Procedure
1. Set the treadmill circuit breaker in the "OFF" position. Remove the AC line cord from the AC
outlet.
2. Disconnect the speed sensor cable plug from the JK2 connector on the LPCA.
3. Remove the two #1 Philips screws that secure the speed sensor to the mounting bracket.
4. Remove the speed sensor and cable from the treadmill.
5.
Reinstall the replacement sensor on the sensor mounting bracket and secure using the two
#1 Philips screw fasteners. Torque the mounting screws to 25 inch pounds.
6.
Route the cable and secure to frame with cable ties. Connect the sensor cable to the
LPCA JK2 connector.
7. Set the treadmill circuit breaker in the "ON" position and verify treadmill operation.
8. Verify operation and return for service...
Replacing the Drive Motor
Procedure
The drive motor and flywheel are balanced as a matched pair. Since the flywheel is balanced
to a specific motor, flywheels should not be removed from one and installed on a different
motor. If the drive motor is replaced, the drive motor and flywheel should be replaced as a unit.
©2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 26 of 56