Precor Energy Series Service Manual page 48

CAUTION: You have approximately 3 seconds before the treadmill running belt begins to move after
pressing Quick Start. Ensure you are in the proper position.
WARNING: Press the safety stop key if the towel becomes loose to prevent it from being pulled into
the treadmill's rollers.
4. The treadmill will begin to run at 1 mph. Allow the treadmill to run for one minute while
keeping the towel firmly in place.
WARNING: Do not adjust the treadmill's speed or run it higher than 1 mph.
5. After one minute, stop the treadmill by pressing the STOP button.
6. When the belt has fully stopped moving, remove the STOP key tether, exit the treadmill, and
turn the power switch to OFF.
7. Grasp both sides of the towel and run it up and down the length of the belt several times to
clean the top of the deck.
8. Remove the towel from beneath the belt.
9. Turn the power switch to ON.
10. Verify operation and return to service.
©2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 48 of 56