Electrical System; Cranking System - Kubota D1102-B Workshop Manual

(A)

Electrical System

(b)
(c)
0073F021
(A) N-30 Construction
li)
(a)
(d)
(el
(f )
(g)
0011?237
(a) Field Coil (I ) Magnet Switch
(b) Brush Spring (m) Pull-in Coil
(n) Moving Core
(c) Brush Holder
(o) Drive Lever
(d) Brush
(e) Commutator (p) Drive Spring
(q) Lever Set Bolt
(f ) Through Bolt
(r) Bearing
(g) Pole Core
(h) End Frame (s) Drive Side Housing
(t) Overrunning Clutch
(i) Contact Bolt
(u) Armature
(j) Contact Plate
(v) Yoke
(k) Holding Coil
(e)
(v)
(u)
(g)
0 0
(a)
ls)
(t)
23
(h)
5-1 CRANK ING SYSTEM
The cran ki ng system consists
of a battery of 12V, magnet
sta rter, glow pl ugs a nd a oi l
switch.
Starter
1 )
The magnet-switch ty pe starter
is composed of two mai n
section.
The f i rst section converts ele-
ctrical energy i nto mechan ical
rotatio n to tu rn the engi ne
cran kshaf t. I t is composed of
the f ield coi l, armatu re, brush,
com mutator, pin ion, over ru n-
n i ng clutch, etc.
The second section al lows the
pi nion and f l ywheel to engage
together and cu rrent to f low
throug the motor section. I t is
composed of the pu l l- i n coi l,
hold i ng coi l , pl unger, d ri ve
lever, contact plate, etc.
KiSC issued 09, 2007 A