Fuel System Servicing; Cleaning Air Cleaner Element; Testing Opening Pressure Of Nozzle - Kubota D1102-B Workshop Manual

0071 F001
0071F 002
3TLABAB1 P040A
CE,

Cleaning Air Cleaner Element

For a dry type element
1) How to clean by using compressed air:
Directly blow compressed air from inside to outside.
Pressure of compressed air must be under 205kPa
(2.1kgf/cm
2) How to clean by using solution:
Add 15 g
1 liter
solution for 15 minutes and then wash it well in the
solution. R inse well in clean water and dry.
01102-B
01302-B
01402-B
• To remove d i rt and dust, use compressed air.
• To remove carbon and grease, use solution.
V1502-B
V1702-B
V1902-B
0
Testing Open i ng Pressu re of Nozzle
1) Move the tester handle up and down to prime fuel.
Measure the pressure of fuel gushing out from the nozzle
tip.
2) If the measurement is not within the reference value,
adjust with the adjustment washer inside the nozzle
holder. (See page 76) An increase of every 0.1 mm
( 0.0039
980.6
injection pressure.
( Danger)
• Be caref ul not to touch the injected fumes directly. On
touchi ng flesh, the f u mes destroy the organism. If it gets
i n the blood, it may cause blood poisoni ng.
55
2
,30psi).
(0.03
lb.) Kubota genuine element detergent to
(0.26
gal.) water. Let the element soak in the
in.) of washer thickness causes an approximate
2
kPa. ( 10 kgf/cm 142.2 lb./sq.in.) increase in fuel
,
,1 - otr: g -:-1
1990.8
- ----· · ·
2133.0 l b.ls
to
KiSC issued 09, 2007 A