Checking Gap Between Shaft And Bush (Magnet Switch Type); Checking Bearing (Reduction Type) - Kubota D1102-B Workshop Manual

Checking Gap between Shaft and Bush
(Magnet Switch Type)
Measu re the i nside d iameters of the beari ng bush i ngs on
1 )
the side of the d ri ve and comm utator.
2) Measu re the d rive-side
d iameters and calculate the gap.
I f the ga p exceeds the allowa ble l i mi t, use an u ndersi ze
3)
bush.
- - - - - -
• Dia me ter s of sh aft and
Drive shaft dia.
Commutator shaft dia.
Drive bushing ID
Commutator bushing ID
Cl)

Checking Bearing (Reduction Type)

Apply torq ue to the i n ner ri n g with you r fin ger ti ps and
1 )
check to see if i t tu rns smoothl y.
2) Check to see if there a re a ny stran ge noises when d ri ven
quickl y.
96
and comm utator-side
- - --
D1102-B, D1302-B
bu sh
12.5mm, 0.4921 in.
12.5mm, 0.4921 in.
1 2.54mm, 0.4937 in.
12.56mm, 0.4945 in.
KiSC issued
shaf t
09, 2007 A